Touch Monitor

Features
    ST6001U is the newest controller supplied by Generaltouch.
 · 10ms conversion time
 · Support size of touchscreens from 6.4’ to 22’ without
       jumper setting
 · touch sensitivity can be adjusted in 5 levels
 · Operation temperature from 0°C to 70°C

Construction
     ·Multi-layer surface-mount design with internal ground plane for EMI suppression

------------------------------------------------------------------------------------------------------------------------------------------------

Supply Voltage and Current
+12VDC，normal (+9V to +15Vdc)
95mA, typical at +12VDC, Average power consumption is 1.2W, typical.
Supply must be capable of sourcing 200mA, minimum.
Total noise and ripple requirement must be less than 100mV (p-p) for frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz.

Interface
USB 1.1

Operation Mode
Support UP/STREAM/DOWN and Z Axis Modes

Touch Resolution
4096x4096, size independent, 256 levels of Z axis(pressure)

Conversion Time
Approximately 10 ms per coordinate set (including transmitting time)

Reliability
MTBF is more than 300,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 25℃

Flammability
The printed circuit board substrate is rated with 94V0.

ESD
Per EN 61000-4-2: Contact discharge 4kV, air discharge 8KV.

Environmental Temperature
Operation: 0°C ~70°C
Storage: -20°C ~ 85°C

Relative Humidity
Operating: 10% to 90%, non-condensing
Storage: 10% to 90%, non-condensing