Touch Monitor

Construction
 •Multi-layer surface-mount design with internal ground plane for
      EMI suppression






------------------------------------------------------------------------------------------------------------------------------------------------

Supply Voltage and Current
+12VDC，normal (+11V to +13VDC)
220mA, typical at +12VDC, Average power consumption is 2.6W.
Supply must be capable of sourcing 350mA, minimum.
Total noise and ripple requirement must be less than 100mV (p-p) for frequencies below 1 MHz,
and less than 50 mV (p-p) for frequencies above 1 MHz.

Interface
USB1.1

Baud Rate (only serial port)
9600

Operation Mode
Support T and C Mode Protocols (only ST6101S)
Support UP/STREAM/DOWN and Z Axis Modes

Touch Resolution
4096x4096, size independent, 256 levels of Z axis (pressure)

Conversion Time
Approximately 16 ms per coordinate set (including transmitting time)

Reliability
MTBF is more than 300,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground
benign environment with an ambient temperature of 25℃

Flammability
The printed circuit board substrate is rated with 94V0.

ESD
Per EN 61000-4-2: Contact discharge +4kV, air discharge +8KV.

Environmental Temperature
Operation: controller: 0°C ~70°C screen: -20°C ~ 50°C
Storage: controller: -20°C C ~80°C screen: -40°C ~ 70°C

Relative Humidity
Operating: 10% to 90%, non-condensing
Storage: 10% to 90%, non-condensing